I don’t feel like a complete idiot after today. I had emailed with a dealer that could do some work on my tractor and mentioned that my rotary mower had lost the pan and blades. They told me to bring it up and they’d take a look, so with some time today, I decided to head up and see what they could do.
It’s a long drive, about 60 miles from the house, but these were nice guys (unlike the crew in Parker), so I loaded the mower into the back of the horse trailer and headed up. It’s a nice, easy drive, and I was on the phone most of the way, doing work, so it wasn’t a complete waste.
I got up there, and two guys came to look at it. They were as confused as I was in trying to figure out how this was attached, especially with a nut still on the bottom shaft.
Then the guy in charge came over, tipped it higher, and took a closer look. He told me that there was no nut on it. It was welded on and the weld broke.
Apparently, just above the not and notched pieces, that round part was welded to the blade pan. Not a great design, but a cheap one and this is a (relatively) cheap mower.
I feel better, though a little dumb for not pushing this sooner. I’ve been looking for a local place to work on it and a few places have been hesitant, most wanting to sell me a new bush hog instead. These guys were friendly, and they said it would take about a week, so I’m looking forward to seeing it working again.
It definitely pays to find good service people and be ready to call them. I’d have never thought about that.
No comments:
Post a Comment