I bought a refurbished Rigid Planer last year and it’s been sitting in a box in the garage for a long time. I’ve been busy, and the projects I’ve tackled haven’t required more than jointing one side.
However I wanted to laminate some boards together and build a bench, and needed to get everything to the same thickness. Two weeks ago I unpacked the planer and put it on a mobile cart I had. There were legs in it, which I hadn’t expected, and I wasn’t sure if I wanted to use them.
A week ago, I dug through the parts and instructions, looking over things, but didn’t feel like doing anything.
Today I decided to do something. No instructions for the legs, but they’re simple metal bolt together legs. I leaned that I connect the top and bottom part of each leg with one bolt, saving the other one for the cross braces. I bolted the cross braces together, and then tightened everything once I was done. About 10-15 minutes to assemble it.
I stuck it out of the way in the garage, and then carried the planer over to it. It’s heavy, but it fit right on top, and four bolts easily held it down to the legs assembly. Once it was done, this is what it looked like:
The instructions say to clean off the oil from metal parts, but there really wasn’t any. Perhaps because this was a refurb? I did have to remove a plastic coating from the interior bed.
I just wanted to test it, so I grabbed the three pieces I needed sized, already jointed on one side. I lowered the bed to a rough spot where I’d rip off about 1/4” of stuff and fed one through.
It came out the other side, and looked like I had two parallel sides.
I quickly ran through all three pieces, and then looked like they were consistently the right size. I glued them together, and we’ll see tomorrow how they look.
No comments:
Post a Comment